최신Huawei HCIP-Transmission V2.0 - H31-341-ENU무료샘플문제

A. Fiber connection exists only on the local network management side.

B. Fiber connection only on the NE side.

C. The fiber connection exists on both the network management side and the network element side.

D. Fiber connection that does not exist on the network management side and the NE side.

A. For OSN 1800 devices, you can use the OTU with dual-selection to protect your business.

B. In-board 1+1 protection can be applied to chain networking and ring networking.

C. The 1+1 protection on the board can protect the OTU board.

D. Set the OTU as the detection unit, and the electrical layer alarms such as OTUk_LOF and OTUK_LOM will also trigger the switching.

A. FALSE

B. TRUE

A. Network first, then network element

B. Advanced first, then low level

C. External first, then transfer

D. Low speed first, then high speed

A. The PM_BIP8_OVER alarm indicates the PM segment error amount of the ODU layer is over-limit alarm.

B. The PM_BIP8_SD alarm indicates the PM segment signal degradation alarm in the ODU layer.

C. The PM_BIP8_DEG alarm indicates the PM segment signal degradation alarm in the ODU layer.

A. Field maintenance personnel cannot understand the current operating condition of the equipment.

B. The network administrator cannot obtain the current notifications of the device, the alarm occurrence time, and the historical alarm of the device.

C. In the case of complex networking, service, and fault information, many alarms and performance events may occur along with the occurrence of faults. Due to too many reports and performance events, maintenance personnel are unable to analyze.

D. When some faults occur, there may be no obvious alarms or performance events reported, and sometimes no alarms or performance events are found.

A. <25dB

B. <20dB

C. >20dB

D. >25dB

A. FALSE

B. TRUE

A. The optical layer path and the electrical layer path are independent. It is not necessary to delete the electrical layer path when deleting the optical layer path.

B. When the OCh path exists, you can directly create a client path. The NMS automatically creates an ODUk path.

C. The optical layer path must be deleted first when the electrical layer path is removed.

D. Deactivation will delete the configuration of the U2000, which has no impact on the device side services.