최신Fortinet NSE 7 - SD-WAN 6.4 - NSE7_SDW-6.4무료샘플문제

A. Dynamic routing protocols can be used only with non-encrypted traffic

B. Adding static routes must be enabled on all ADVPN interfaces.

C. VPN topologies must be form using only BGP dynamic routing with SD-WAN

D. Learned routes can be used as dynamic destinations in SD-WAN rules

A. When configuring an SD-WAN rule, you can select multiple SLA targets of the same performance SLA.

B. SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy.

C. Member metrics are measured only if an SLA target is configured.

D. SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements.

A. ADVPN

B. SSLVPN

C. OCVPN

D. GRE

A. Member interfaces that are physical interfaces as well as VLAN aggregate, and iPsec interfaces

B. Member interfaces that are referenced by any other configuration element

C. Member interface that have IP address of 0.0.0.0/0.0.0.0

D. Member interfaces that are administratively down

A. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.

B. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

C. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

D. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.

A. diagnose sys virtual-wan-link service

B. diagnose debug application ike

C. get router info routing-table

D. get ipsec tunnel list

A. Type of physical link connection

B. Application signatures

C. URL categories

D. Internet service database (ISDB) address object

E. Source and destination IP address

A. XAuth is enabled as an additional level of authentication, which requires a username and password.

B. A peer ID is included in the first packet from the initiator, along with suggested security policies.

C. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.

D. A total of six packets are exchanged between an initiator and a responder instead of three packets.

A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.
D18912E1457D5D1DDCBD40AB3BF70D5D

B. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.

C. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.

D. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.