최신Oracle Communications Session Border Controller 7 Basic Implementation Essentials - 1z1-404무료샘플문제

A. Type show <element name>.

B. Type show ? and select from the displayed list.

C. Type is -a.

D. Enter the name of the element and then issue the show command.

E. Select the element and then issue the show command.

A. they replace typical edge routers and firewalls in order to provide a unified network border forsignaling and media control

B. they provide signaling proxy functions for SIP, H.323, and MGCP, which includes access control, signaling constraints, and topology hiding

C. they provide routing functions for IP, TCP, and SMTPusing application parameters

D. they are based on the Windows operating system

E. they are session-aware devices that enable control of end-to-end interactive communications across IP network borders

A. The Hosted IP architecture focuses on the border point between one enterprise network realm and one service provider network realm.

B. The Access-backbone architecture focuses on the border point between two backbone realms.

C. The Gateway architecture Focuses on the border point between one enterprise network realm and one service provider network realm.

D. The Hosted NAT Traversal (HNT) architecture focuses on the border point between two different service provider networks, both in the home realm.

E. The Peering architecture focuses on the border point between two different service provider networks and theirrealms.

A. Navigate to the phy-interface configuration element and run the remove-hip-ip <IP address> command.

B. Navigate to the network-interface configuration element and run the remove-hip-ip <IP address> command.

C. Navigate to the phy-interface configurationelement and run the remove-telnet-ip <IP address> command.

D. Navigate to the network-interface configuration element and run the remove-telnet-ip
< IP address> command.

E. Navigate to the network-interface configuration element and run the delete-hip-ip <IP address> command.

A. After configuring a phy-interface configuration element for signaling and/or media, a reboot of the Session Border Controller is required.

B. A phy-interface configuration element for signaling and/or media hasthe operation-type parameter set to control.

C. A phy-interface configuration element must be configured for each interface used.

D. A unique phy-interface configuration element is created for all signaling/media interfaces.

E. A phy-interface elementmust be configured for each interface used for High Availability
(HA) heartbeats, but not for signaling and/or media.

A. There are no default community strings.

B. Only one trap receiver can be configured.

C. The default community stringsare public and private.

D. Community strings are in passive mode.

E. The default community strings are acme and packet.

A. by setting the utility address and sec-gateway values to addresses in different subnets as the IP address configured on the wancom interfaces

B. by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the management interfaces

C. via the utility address parameters on the wancoml and wancom2 interfaces

D. by setting a unique address on the wancoml and wancom2 interfaces via the utilityaddress command

E. by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the media interfaces