최신F5 BIG-IP Administration Install, Initial Configuration, and Upgrade - F5CAB1무료샘플문제

A. (tmos)# modify /sys httpd allow replace-all-with {10.0.0.0/24}

B. (tmos)# create /net acl MGMT.HTTP rule add { (permit tcp 10.0.0.0/24 10.53.1.245 http) (deny ip any any http) }

C. (tmos)# create /net acl MGMT.HTTP rule add { (permit tcp 10.0.0.0 0.0.0.255 host 10.53.1.245
http) }

D. (tmos)# modify /ltm httpd allow replace-all-with {10.0.0.0/24}

A. The "Port Lockdown" setting is preventing the SNMP server from polling data from the BIG-IP.

B. The "VLAN / Tunnel" setting must allow All Vlans.

C. The configuration on the exhibit is correct and other options should be explored.

D. The "Traffic Group" setting must use a floating Traffic Group.

A. Restrict administrative HTTPS and SSH access to specific IP addresses or IP ranges.

B. Limiting network access through the management interface to a trusted/secured network VLAN.

C. Use the BIG-IP's Self-IP addresses for administrative access rather than the management interface.

D. Block all management-interface administrative HTTPS and SSH service ports to prevent access.

A. Route

B. Pool

C. SSL Profile

D. iRule

A. Log into the remote console and configure the management IP by running the setup command.

B. Log into the remote console and configure the management IP through TMSH using:
create sys management-ip <ip address>/<mask>

C. Log into the remote console and configure the management IP by running the config executable.

D. Log into the remote console and configure the management IP through TMSH using:
create ltm management-ip <ip address>/<mask>

A. To avoid locking out the administrator, recent versions of BIG-IP no longer allow restricting administrator access to the Configuration Utility by source IP address

B. The administrator needs to switch to the "Advanced" view mode in order to display the relevant setting

C. Restricting access to the Configuration Utility can only be done from the Command Line Interface

D. The administrator must restrict access by IP address for SSH, which will implicitly restrict access to the Configuration Utility

A. Connectivity to the DNS server failed to be established.

B. The license needed to be reactivated before the upgrade.

C. The upgrade was performed on the standby unit.

D. A minimum of at least two reboots is required.