최신H3CSE-RS-SW - GB0-372-ENU무료샘플문제

A. RT2 inbound interface list: Port1

B. RT1 inbound interface list: Port1

C. RT2 outbound interface list: Port2, Port3

D. RT1 outbound interface list: Port2, Port3

A. After RTA is sent, RTB is the Master router of the backup group

B. RTA is the Master router of the backup group

C. RTB is the Master router of the backup group

D. RTC is the Master router of the backup group

A. 00E0.FC00.0010

B. 0011.1111.1111

C. 0000.0000.0000

D. 00E0.FC00.0020

A. If the links of the upstream switches SWD and SWE of switch SWH are both in Down state, the primary port of the Smart Link group of switch SWJ will be switched to the secondary port.

B. If the link of switch SWH to switch SWE is down, the primary port of the Smart Link group of switch SWJ will switch to the secondary port.

C. The Smart Link group status of switch SWJ has nothing to do with switch SWH

D. If the link of switch SWH to switch SWD is down, the master port of switch SWJ Smart Link group will switch to the slave port.

A. FTP

B. PPP

C. SSH

D. Port access

A. IGMPvl

B. IGMPV2

C. IGMPV3

D. MLDvl

E. MLDV2

A. You need to enable the local proxy ARP function in the VLAN10 view of SWA so that PCA can communicate with PCB.

B. The local proxy ARP function needs to be enabled in the VLAN20 view of SWB so that PCA can communicate with PCB.

C. PCA can communicate directly with PCB without additional configuration

D. The local proxy ARP function needs to be enabled in the VLAN10 virtual interface view of SWA so that PCA can communicate with PCB.
E You need to enable the local proxy ARP function in the VIAN20 virtual interface view of SWB so that PCA can communicate with PCB.

A. The ports on switches SWA, SWB, and SWCRRPP rings that access the RRPP ring need to be added to VLAN 4092

B. All ports on switches SWA, SWB, and SWC need to be added to VLAN 4092

C. To facilitate network management, you can configure an IP management address on VLAN 4092.

D. The primary ring control VLAN on switches SWB and SWC can be different from that on SWA.

A. Configuration Management

B. Fault Management

C. Topology Management

D. Performance Management

E. Equipment Management

A. RT3

B. RT4

C. RT2

D. RT1

A. IGMPv1 does not have leave messages

B. IGMPV2 and IGMPV3 designed a member reporting suppression mechanism

C. The election principles of the three version queryers are the same

D. IGMPV2 and IGMPV3 have specific group query messages

E. Only IGMPV3 has a specific group joining mechanism

A. PCA and PCC can communicate with each other

B. The configuration command is incorrect

C. The three PCs cannot communicate with each other

D. PCA and PCB can communicate with each other

E. PCB and PCC can communicate directly

A. When a multicast source initially sends traffic, an (S, G) entry is formed on the DR connected to it.

B. Upon receiving a registration message from a multicast source, the RP sends a join message to the multicast source and generates an (S, G) entry only when it receives normal multicast traffic from the multicast source.

C. RP will forward multicast traffic downstream only after receiving multicast data forwarded by the multicast source

D. Before the multicast traffic is forwarded from the RP to the multicast receiver, all routers along the way have established (*, G) entries.

A. Configuration BPDU is only sent from the designated port, and TCNBPDU is only sent from the root port.

B. Alternate ports will neither send configuration BPDUs nor TCNBPDUs

C. Configuration BPDU is usually received only from the root end, and TCNBPDU is received only from the designated port.

D. Configuration BPDU is usually only sent periodically by the root bridge, while TCNBPDU may be sent by other bridges except the root bridge.