최신NCARB ARE 5.0 Project Development and Documentation - PDD무료샘플문제

Refer to the exhibit.
An architect is designing a multipurpose room that will operate daycare services as well as exercise classes.
The multiple occupancies within the space utilize components of the same means of egress system.
What is the occupant load factor that should be used in calculating egress?

Refer to the exhibit.
An architect is working on an airport lounge project. The 9,000 SF floor plan includes an open, double-height space. Due to area limitations, all program requirements cannot fit within the 9,000 SF floor plan. A mezzanine level with one exit is being proposed to solve this programming constraint. There are adequate exits available on the main floor plan to pick up the additional occupant load from the mezzanine.
Which method of mezzanine construction should the architect design?
Which of the following documents would the architect need in order to prepare the specifications?
In winter conditions, when the outdoor air is below freezing and the indoor humidity is maintained at 40 percent relative humidity for 24 hours a day, ice forms on the exterior surface of the stone facing.
Which of the following elements is missing from the building wall section?
Given the information below, which of the following is the cost of 1,850 sq. ft. of brick veneer?
* Cost of brick - $500 per 1,000 brick
* Cost of masonry cement, sand, etc. - $160 per 1,000 brick
* Cost of labor - $675 per 1,000 brick
* 680 bricks per 100 sq. ft.
* 5% waste of material

Refer to the exhibit.
The construction method shown in the detail should be used to prevent cracking in which of the following situations?
Which of the following is most appropriate to coordinate ceiling-mounted HVAC diffusers?


An architect is designing a school building that features a flat roof with a low parapet wall in a wet climate region. The client wants to minimize maintenance requirements and focus on keeping water from the walls.
What parapet coping detail would be most appropriate for the architect to select for this project?
In which of the following locations in concrete masonry should a control joint be placed?
In addition to reducing heat conductance, the thermal break in the construction of metal window frames does which of the following?