최신BICSI Registered Communications Distribution Designer - RCDD-001무료샘플문제

문제1
You must place CAT6 cable above a factory floor with automated welding machines and hammer forges.
Of the following, what type of shielding would be most effective?

정답: E
문제2
Assuming the total fill capacity of a pathway is 100 cables (all of the same cable type and size), the
MAXIMUM number of cables to be installed during the initial installation, without exceeding the fill ratio is:

정답: D
문제3
A large telecommunications facility, by most codes, must be designed with an EPO switch located at:

정답: B
문제4
You have been asked to test and troubleshoot an installed base of cabling that is believed to be causing
network problems. You are finding that there are high levels of return loss upon initial testing. What testing
will best determine the reasons for these failures?

정답: B
문제5
"A single outlet utilizing a dedicated phase, neutral, and ground conductor" is the definition for which of
the following?

정답: A
문제6
A building has six floors plus a basement. Each floor is 10,000 square feet and has approximately 50
CATV outlets respectively. There is a single hardline trunk cable installed from the basement headend
passing through a directional coupler in each floor's telecommunications room (TR). Which leg of the
coupler will have the LEAST signal loss?

정답: D
문제7
If you have a circuit with 120 volts, 12 amps, and 10 ohms, it has a peak power of ________ watts.

정답: B
문제8
The recommended MAXIMUM value for the bonding resistance between the nearest available grounding
electrode and the busbar in an entrance facility (EF) is ________ ohms.

정답: D
문제9
You are preparing to test newly installed open office cabling. Within the open office cabling, there are
multiple consolidation points (CP) that were installed while waiting for furniture. How do you proceed with
permanent link testing?

정답: A
문제10
Route congestion and message priority are a few of the functions of what layer of the OSI Model?

정답: D
문제11
Which one of the following is NOT an advantage of underground conduit?

정답: E
문제12
Which of the following is NOT considered acceptable in an information technology system (ITS) conduit
design and installation?

정답: C
문제13
You have been asked to design a backbone cable connecting two large campus buildings. Your pathways
will include using conduits, maintenance holes, and one section of 100 m (328 ft) of direct buried optical
fiber cable. Your choice of fiber optic cable type recommendation is a:

정답: E
문제14
A space has all hard surfaces including architecture and furnishings. The audio programming produced
from the distributed sound system has become unintelligible. Which of the following will NOT mitigate the
problem?

정답: B
문제15
Time division multiplexing (TDM) systems are designed to transport ________ between end point
systems.

정답: D
문제16
One interior TTY must be provided at locations defined as public accommodations with ________ or more
pay telephones.

정답: D
문제17
Exhibit:

In this future marina layout, what would be the pre-cabling guideline to follow for the terminal A?

정답: C
문제18
You are designing an audible alarm notification system for an office environment with an ambient noise
level of 55 dBA. What dBA level should the horn be set at?

정답: D

자격증의 중요성:

ITDumpsKR 경쟁율이 심한 IT시대에 인증시험을 패스함으로 IT업계 관련 직종에 종사하고자 하는 분들에게는 아주 큰 가산점이 될수 있고 자신만의 위치를 보장할수 있으며 더욱이는 한층 업된 삶을 누릴수 있을수도 있습니다.

ITDumpsKR 제품의 가치:

ITDumpsKR에는 IT인증시험의 최신 학습가이드가 있습니다. ITDumpsKR의 IT전문가들이 자신만의 경험과 끊임없는 노력으로 최고의 학습자료를 작성해 여러분들이 시험에서 패스하도록 도와드립니다.

무료샘플 받아보기:

관심있는 인증시험과목 덤프의 무료샘플을 원하신다면 덤프구매사이트의 PDF Version Demo 버튼을 클릭하고 메일주소를 입력하시면 바로 다운받아 덤프의 일부분 문제를 체험해 보실수 있습니다.

완벽한 서비스 제공:

ITDumpsKR는 한국어로 온라인상담과 메일상담을 받습니다. 덤프구매후 일년동안 무료 업데이트 서비스를 제공해드리며 구매일로 부터 60일내에 시험에서 떨어지는 경우 덤프비용 전액을 환불해드려 고객님의 부담을 덜어드립니다.